Unique thermal properties discovered in 2-D black phosphorus nanoribbons

 

Berkeley Lab researchers have experimentally confirmed strong in-plane anisotropy in thermal conductivity along the zigzag (ZZ) and armchair (AC) directions of single-crystal black phosphorous nanoribbons. Credit: Junqiao Wu, Berkeley Lab A new experimental revelation about black phosphorus nanoribbons should facilitate the future application of this highly promising material to electronic, optoelectronic and thermoelectric devices. A team of researchers at the U.S. Department of Energy (DOE)'s Lawrence Berkeley National Laboratory (Berkeley Lab) has experimentally confirmed strong in-plane anisotropy in thermal conductivity, up to a factor of two, along the zigzag and armchair directions of single-crystal black phosphorus nanoribbons. "Imagine the lattice of black phosphorus as a two-dimensional network of balls connected with springs, in which the network is softer along one direction of the plane than another," says Junqiao Wu, a physicist who holds joint appointments with Berkeley Lab's Materials Sciences Division and the University of California (UC) Berkeley's Department of Materials Science and Engineering. "Our study shows that in a similar manner heat flow in the black phosphorus nanoribbons can be very different along different directions in the plane. This thermal conductivity anisotropy has been predicted recently for 2D black phosphorus crystals by theorists but never before observed." Wu is the corresponding author of a paper describing this research in Nature Communications titled "Anisotropic in-plane thermal conductivity of black phosphorus nanoribbons at temperatures higher than 100K." The lead authors are Sangwook Lee and Fan Yang.  Black phosphorus, named for its distinctive color, is a natural semiconductor with an energy bandgap that allows its electrical conductance to be switched "on and off." It has been theorized that in contrast to graphene, black phosphorus has opposite anisotropy in thermal and electrical conductivities -- i.e., heat flows more easily along a direction in which electricity flows with more difficultly. Such anisotropy would be a boost for designing energy-efficient transistors and thermoelectric devices, but experimental confirmation proved challenging because of sample preparation and measurement requirements. "We fabricated black phosphorus nanoribbons in a top-down approach using lithography, then utilized suspended micro-pad devices to thermally isolate the nanoribbons from the environment so that tiny temperature gradient and thermal conduction along a single nanoribbon could be accurately determined," Wu says. "We also went the extra mile to engineer the interface between the nanoribbon and the contact electrodes to ensure negligible thermal and electrical contact resistances, which is essential for this type of experiment." The results of the study, which was carried out at the Molecular Foundry, a DOE Office Science User Facility hosted by Berkeley Lab, revealed high directional anisotropy in thermal conductivity at temperatures greater than 100 Kelvin. This anisotropy was attributed mainly to phonon dispersion with some contribution from phonon-phonon scattering rate, both of which are orientation-dependent. Detailed analysis revealed that at 300 Kelvin, thermal conductivity decreased as the thickness of the nanoribbon thickness shrank from approximately 300 nanometers to approximately 50 nanometers. The anisotropy ratio remained at a factor of two within this thickness range. "The anisotropy we discovered in the thermal conductivity of black phosphorus nanoribbons indicates that when these layered materials are patterned into different shapes for microelectronic and optoelectronic devices, the lattice orientation of the patterns should be considered," Wu says. "This anisotropy can be especially advantageous if heat generation and dissipation play a role in the device operation. For example, these orientation-dependent thermal conductivities give us opportunities to design microelectronic devices with different lattice orientations for cooling and operating microchips. We could use efficient thermal management to reduce chip temperature and enhance chip performance." Wu and his colleagues plan to use their experimental platform to investigate how thermal conductivity in black phosphorus nanoribbons is affected under different scenarios, such as hetero-interfaces, phase-transitions and domain boundaries. They also want to explore the effects of various physical conditions such as stress and pressure. Story Source: The above post is reprinted from materials provided by DOE/Lawrence Berkeley National Laboratory. Note: Materials may be edited for content and length. Journal Reference: Sangwook Lee, Fan Yang, Joonki Suh, Sijie Yang, Yeonbae Lee, Guo Li, Hwan Sung Choe, Aslihan Suslu, Yabin Chen, Changhyun Ko, Joonsuk Park, Kai Liu, Jingbo Li, Kedar Hippalgaonkar, Jeffrey J. Urban, Sefaattin Tongay, Junqiao Wu. Anisotropic in-plane thermal conductivity of black phosphorus nanoribbons at temperatures higher than 100 K. Nature Communications, 2015; 6: 8573 DOI: 10.1038/ncomms9573   http://www.sciencedaily.com/releases/2015/10/151016135329.htm