Tue, 08/04/2015 - 12:10pm
Laura Mgrdichian, Brookhaven National Laboratory
Simon Billinge, author on the paper and a physicist with a joint position at Brookhaven National Laboratory and Columbia Univ.'s School of Engineering and Applied Science.The world’s newest and brightest synchrotron light source—the National Synchrotron Light Source II (NSLS-II) at the U.S. Dept. of Energy (DOE)’s Brookhaven National Laboratory—has produced one of the first publications resulting from work done during the facility's science commissioning phase.
Published July 7 in the online edition of the International Union of Crystallography Journal, the paper discusses a new way to apply a widely used local-structure analysis tool—known as atomic pair distribution function (PDF) analysis—to x-ray scattering data from thin films, quickly yielding high-quality information on the films' atomic structure. The work creates new avenues for studies of nanocrystalline thin films.
This work shows that NSLS-II—a DOE Office of Science User Facility with ultra-bright, ultra-concentrated x-ray beams—is already proving to be a game-changer in studies of thin films, which play a vital role in a large number of technologies, including computer chips and solar cells.
In GI studies, the x-ray beam grazes the surface of the film such that it reflects off the substrate, allowing the beam to illuminate as much of the film as possible while minimizing penetration through the film into the substrate. However, the small angle of incidence makes GI studies notoriously difficult to carry out and introduces serious complexities in data analysis.
“Grazing-incidence diffraction experiments are tricky for crystalline materials, and have never successfully been done to obtain PDFs from films,” said one of the paper's authors, Simon Billinge, a physicist with a joint position at Brookhaven and Columbia Univ.'s School of Engineering and Applied Science. “The experiments are too painstaking and the data analysis is extremely challenging.”
Studying the “atomic neighborhood”
The approach that Billinge and his colleagues devised leverages the high fluxes of photons coming from NSLS-II, which, together with novel data reduction methods recently developed in his group, creates data suitable for PDF analysis from a thin film. Essentially, it turns the standard GI experiment on its head: the beam is simply sent through the film from the back to the front.
Eric Dooryhee, the lead scientist for the NSLS-II X-Ray Powder Diffraction (XPD) beamline, where the work was done, explained, “The first group of NSLS-II beamlines is now successfully transitioning from technical commissioning, which began back in the fall of 2014 when we first produced x-ray light, towards science commissioning, where we benchmark and test the beamline capabilities on real samples. Extracting the thin film's tiny signal from the substrate's large signal in this normal-incidence geometry is extremely technically difficult. Nonetheless, I told Simon that XPD should be up to the challenge.”
Preview of future breakthroughs
The first sample studied was an amorphous iron-antimony film on an amorphous borosilicate substrate mounted perpendicular to the x-ray beam. In order to isolate the contribution from the film, the substrate contribution was first determined by measuring the scattering pattern from a clean substrate. The signal from the film is barely visible in the raw data on top of the large substrate contribution, but could be clearly extracted during data processing. This allowed for a reliable, low-noise PDF that can be modeled successfully to yield the quantitative atomic structure of the film.
The data led to high-quality PDFs for both amorphous and crystalline films—confirmed by comparison to control samples in a standard PDF setup. Based on the success of these first measurements, the Billinge group and the XPD team are now planning future experiments to watch the films crystallize in real time, in the beam.
“The discovery that we can get PDFs from samples in thin-film geometry so readily will revolutionize this area of science,” said Kirsten Jensen, a postdoctoral researcher in Billinge’s group at Columbia. “The experiments don’t take any specialized equipment or expertise beyond the beamline setup at XPD and are quick, opening the way to time-resolved in-situ studies of changes in film structure under processing as well as spatially resolved studies of nanostructured films in place.”
Added Billinge, “This is an exciting new result by itself, but it only gives us a glimpse of the possibilities that NSLS-II will present as the power ramps up over the next few years. This is the tip of the iceberg of what will be possible when NSLS-II is operating at full power.”
Source: Brookhaven National Laboratory